Is Electricity Cheaper at Night? What Running Appliances Off-Peak Saves

By , ElectricityUsageCalculator.com

Electricity is cheaper at night only on time-of-use plans, where moving a dryer load saves about 40 cents and an EV charge $3 or more.

On a flat rate, which most U.S. homes are still on, a kWh at 3 am costs exactly what it costs at 6 pm, so running the dishwasher after midnight saves nothing. Both savings figures use the typical plan prices in the table below.

Below: how to tell which situation you are in, when the cheap hours actually fall (not always at night anymore), and a per-appliance table of what each shift is worth. The companion guides cover the peak and off-peak windows at seven large utilities and whether a time-of-use plan would pay for your household.

Why the answer depends on your rate plan

The electricity itself really is cheaper to produce at night. Grid demand bottoms out around 5 am and tops out around 5 or 6 pm in summer, according to the Energy Information Administration's analysis of hourly electricity consumption, and wholesale prices follow that curve. What reaches your bill is a different question. A flat residential rate averages the whole day into one price, so the utility pays less for your 3 am kWh but charges you the same. Only a time-of-use (TOU), time-of-day or EV plan passes the difference through, and the Federal Energy Regulatory Commission's 2025 demand response assessment put enrollment in all forms of dynamic pricing at roughly 11% of U.S. electric customers in 2023.

So the first job is to find out which kind of customer you are. A bill with a single cents-per-kWh figure (or tiers that step up with monthly usage, not with the clock) means the hour is irrelevant to your cost, and you can skip to what still helps. A bill that breaks usage into on-peak and off-peak kWh at two different prices means every section below applies to you, and the gap between those two prices is the number that sets your savings.

What time is electricity cheapest at night?

For the majority of time-of-use plans the cheap block starts when the evening peak ends, between 7 and 9 pm, and runs until 6 to 8 am, and on plans like APS's, Xcel's and Georgia Power's, all of Saturday and Sunday too. The actual boundaries at a few large utilities, from their own rate pages:

Within the overnight block the price is usually flat, so 10 pm and 4 am cost the same. There is no bonus for staying up later; a delay-start timer set for 9:30 pm is enough. The full windows, including the mid-peak tiers some plans add, are in the utility comparison table on the peak hours page.

When midday is cheaper than night

In states with a lot of rooftop solar night is no longer always the cheapest time. Midday demand on the grid now drops so low in the cooler months that some utilities price it below the overnight rate. On APS's winter schedule, weekday hours between 10 am and 3 pm are billed at 3.495 cents per kWh, against 12.351 cents for the ordinary off-peak hours overnight. Southern California Edison's TOU-D-4-9PM plan prices 8 am to 4 pm in winter (October to May) as super-off-peak at 32 cents, below the 36 cent overnight rate. EIA's June 2026 analysis of New York's grid explains why: small-scale solar has carved out the middle of the day and made the 4 to 7 pm evening ramp steeper, so the expensive hours are shifting later and the cheap hours are splitting into two blocks.

If you are on one of those plans, the dishwasher's best start time in January is after breakfast, and an EV that sits at home on weekdays should charge at lunchtime in winter and overnight in summer. Check whether your plan has a midday tier before you build a habit around midnight.

What shifting each appliance saves

The saving from moving a load is the price gap per kWh multiplied by the kWh in that load. The table uses two live price gaps as examples: 13.4 cents per kWh (Xcel Colorado's summer on-peak minus off-peak, 21.277 minus 7.884 cents, from the Colorado PUC) and 22.1 cents (APS's summer gap, 34.396 minus 12.345 cents, from APS). The kWh per use come from the appliance wattages on this site's own guides, which cite the Department of Energy's appliance table, plus ENERGY STAR and this site's EV calculator.

What moving each load off-peak saves
LoadkWh per useWhere the figure comes fromSaved at a 13.4¢ gapSaved at a 22.1¢ gap
Electric dryer, one-hour load3.03,000 W, midpoint of the 1,800 to 5,000 W range in our dryer guide$0.40$0.66
Dishwasher, one cycle1.12ENERGY STAR's ≤240 kWh per year over 215 cycles, from its dishwasher criteria; older or heated-dry cycles run higher (see our dishwasher guide)$0.15$0.25
Washing machine, one-hour load (cold water)0.4425 W, midpoint of 350 to 500 W in our washing machine guide; excludes water heating$0.06$0.09
EV, adding 22.5 kWh to the battery25.6Worked example from our EV charging calculator: 22.5 kWh plus the default 12% charging loss$3.42$5.64

Three household chores moved off-peak are worth 60 cents to a dollar a day combined, which adds up over a year, and all three can be handled with a delay-start button. One EV charge moved off-peak is worth more than all three put together, several times a week, and the car does it on a schedule you set once. For any load not in the table, the electricity usage and cost calculator gives kWh from wattage and hours; multiply by your plan's gap, or run it twice with each price.

Is it cheaper to do laundry at night?

On a time-of-use plan, yes, and the dryer is the reason. The washer itself is a small load (about 0.4 kWh for a cold-water hour), so moving it saves a few cents, but a 3 kWh dryer load moved from Xcel's 6 pm price to its 9:30 pm price saves 40 cents, and 66 cents on APS's summer prices. A household drying five loads a week, about 260 a year, moves 780 kWh. At Xcel's price gap that is roughly $90 a year at the October to May gap of 11.5 cents and $104 at the summer gap, so call it $90 to $105 a year for a laundry habit that costs you nothing except pressing delay start. If the washer uses hot water from an electric water heater, the water heating is a second movable load and the saving grows; our water heater guide covers what that heating draws.

Practical notes. Weekend daytime is off-peak at APS, Xcel, Georgia Power, SCE and PG&E, so on those plans Saturday-morning laundry is as cheap as laundry at midnight and you do not have to be awake for it. Con Edison and ComEd price weekend daytime like weekdays, so check their hours first. If you do run a cycle overnight, a delay-start timer set so the dryer finishes shortly before you get up means clothes are not sitting damp or wrinkling for hours. And on a flat rate none of this matters for cost: wash whenever suits you and put the effort into the cold-water setting and a full load instead.

EV charging saves the most

A home EV charger is the one appliance for which night pricing changes the economics, which is why the utilities build whole plans around it. Charging draws more from the wall than lands in the battery; our EV calculator defaults to a 12% loss, and the Department of Energy's fueleconomy.gov puts battery charging efficiency at 84% to 93%. So a session that adds 22.5 kWh pulls about 25.6 kWh through the meter. On Xcel's summer prices that session costs about $5.44 at 6 pm and $2.02 after 9 pm; on APS's it is the difference between roughly $8.80 and $3.16. Sixteen charges a month, four a week, comes to about $55 a month saved at the Xcel gap and $90 at the APS gap, which lines up with the Brattle Group's observation in its 2023 survey of time-varying rates that EV owners on these plans can cut their charging cost by more than half.

The dedicated EV plans go further. SCE's TOU-D-PRIME charges 26 cents off-peak against 61 cents at summer weekday peak, and ComEd pays a $2 monthly bill credit per enrolled vehicle for up to 24 months on its Time-of-Day rate. Nearly every EV and most Level 2 chargers can be told to start at a set time, so the shift is a one-time setting. If you own an EV and are still on a flat rate, the switching calculation on the time-of-use page is worth ten minutes, because the car alone can make a TOU plan pay.

What shifting will not help

Three things people try that do not pay. Running appliances at night on a flat rate: every kWh is billed at the same price whatever the hour, so nothing changes. Shifting the loads that cannot move: the refrigerator, freezer, router and anything on standby run around the clock and their peak-hour share is fixed, so they are not candidates (what they cost is a usage question, not a timing one, and the appliance guides on this site cover each). And trying to shift lighting or the TV you are watching at 7 pm: the savings are a few cents and the change is a hassle.

What helps on any plan, including a flat one, is using less in the first place: cold-water washing, skipping the dishwasher's heated dry, the dryer's moisture sensor instead of a fixed timer, and a lower water heater setpoint. Those cut kWh at every hour. Timing only adds to them when your plan prices the hours differently.

How to check whether timing matters on your bill

  1. Find the rate schedule line on the bill. A plan name built around hours (time-of-use, time-of-day, an EV or overnight plan) means timing matters; a plain residential schedule with one price does not.
  2. Look at the usage lines. A TOU bill shows on-peak and off-peak kWh separately with two prices; the gap between the prices is your saving per kWh moved.
  3. If you are on a flat rate and curious whether a TOU plan would be cheaper, pull a month of hourly data from your utility's online account and run the peak-share calculation.
  4. Use the kWh cost calculator in reverse: enter a bill's energy charge and kWh to get your effective price, then compare it with the off-peak price on the plan you are considering.
  5. If you want to see your own usage by hour without the utility portal, a plug-in energy monitor or a whole-home monitor will show it; our energy monitor and smart plug guide compares the options, and the smart plugs double as the timers that make shifting automatic.

Cedrick Reese wrote this page for ElectricityUsageCalculator.com so that the "cheaper at night" question gets a number instead of a yes or no. The price gaps are the published on-peak and off-peak energy charges of two named utilities (Xcel Colorado via the state PUC, and APS) and the per-use kWh figures are the same Department of Energy appliance wattages this site's individual appliance guides cite, plus ENERGY STAR's dishwasher criteria and the charging-loss default from this site's EV calculator; the per-load, per-year and per-month savings are straight multiplication of those two inputs and can be checked by hand. Grid timing facts come from two EIA analyses and the FERC demand response assessment. Utility prices and hours are rechecked against the linked rate pages each spring and fall, and whenever a utility announces new prices. The appliance figures follow the appliance guides when their sources change. Last checked November 2026.

Sources

Savings figures on this page multiply published utility energy charges by typical appliance energy use. They exclude fixed charges, riders and taxes, and your own appliances, plan and habits will produce different numbers. Use the linked calculators with your own wattage and rate for a personal estimate.